How do I start my gas scooter?

The answer is simple. Put the choke in the upwards position and pull the starting cord briskly. When you first get your scooter you will need to pull the starter a few more times than usual to get it started (do not forget to pump the primer bulb which is located on the bottom of the carburetor). Once the scooter starts, switch the choke in the down position. Check the video below for more information.

Do gas scooters require maintenance?

Yes. You must check all bolts and fasteners at least once a week. The muffler must be cleaned out at least once every three months.(Check out the video below, for a better explanation on how to clean the muffler.)Check tensioners as well. The air filter must also be cleaned once a month.

If I wanted to take apart my two-stroke engine, how would I know what each part inside is?

Please look at the Two-Stroke Diagram Below:

*Important*

SNOW SCOOTER TIRES:

How do I adjust the Handlebars and Headset? (Please watch the video below)

Does my scooter come with a warranty?

All Go-Ped and BladeZ gas scooters come with a 90 day warranty. X-Treme Scooters come with a 30 day warranty.

What is the gas and oil mixture?

32:1 = 4.1 oz. oil per 1 gallon of gas. (Recommended for Chinese Motors)

50:1 = 2.6 oz. oil per 1 gallon of gas. (Recommended for Japanese Motors)

Gas Scooter Diagram:

Does the carb. modification you have shown me bad for my engine?

It all depends on how you treat the motor. DO NOT leave the engine running at a high rpm for too long or you may damage it.

How do I clean my gas scooter?

DO NOT CLEAN YOUR GAS SCOOTER WITH A HOSE!!! Clean your scooter with a wet rag or paper towel.

Why is my scooter leaking gas and oil?

There might be some gasket damage. Check the fuel lines and the carburetor.

Why is my gas scooter not idling properly?

If your scooter is not idling properly use a Phillips head screw driver and screw in the screw on the side of the throttle. (This is on the carburetor).

How do I break in my new engine?

To break in the engine you must ride your gas scooter only on half throttle for the first tank of gas. After that, you can go full speed ahead.

What kind of safety equipment must I use riding my scooter?

The preferred safety equipment are helmets, kneepads, and elbow pads.

Is my scooter street legal?

NO, THESE SCOOTERS ARE NOT STREET LEGAL!!!

How long will my engine last?

These Japanese engines will last 25,000 miles at the least. (Approx: 6 to 10 years) Chinese motors are not high quality, so the lasting time of the motor will be less than the Japanese motors.
   
How do I adjust my chain/belt?

In order to do that, you must loosen the tensioners and the axle. Then align the wheel with the sprocket. Once aligned, tighten the ax el and tensioners.

How do I adjust my breaks?

To adjust your brakes simply grab a wrench and unscrew a bolt right above the disk break pads. This aligns the breaks as well as tightening them up.

What kind of lubricant should I use for my belt?

Use wax lubricant.

What kind of lubricant should I use for my chain?

You may use WD40 or normal bike chain lubricants.

How do I change a Flat Tire? (Watch the video below):

Don't let your scooter turn out like this:

How do I increase performance of my scooter without buying HP(High Performance)Parts? (Watch the Video below)

How to Speed up your engine without any HP parts:

Back to Top